 |
| RoHS Tornado Infra held station |
|
 |
294.42 USD w/o VAT
If You are EU customer w/o only when You have valid VAT number
362.14 USD Otherwise
|
Tornado Infra held station it's first hand held infra rework station. Here is an honest attempt to give infra rework at reasonable price without any degradation in quality. Our product has been built using one of the best infrared techniques an best to use with lead-free PCB's.
Most common questions:
Q: What more can it do than a hot air?
A: First since 2006 June all PCBs made all over the world must be lead free PCBs. The melting temperature for lead free solder is 225 °C. Also if you have a PCB with lead free solder wire and if you try using hot air to repair it the PCB tracks can go bad. So there is no other choice but to use INFRA heating station
Specification:
Pre Heater:
# This infrared heating element contains the CE marking.
# The CE marking indicates conformity with the relevant European safety directive(s).
Heating element specifications:
# Iron-chrome aluminum resistance wire
# Heater Voltage: 230 Volts standard.
# Electrical Power Loading: 6.8 W/cm2 (43.5W/inch)
# Useful wavelength range: 2 to 10 Microns.
# Average Operating Life: 5,000 - 10,000 Hours.
# Mean Maximum Surface Temperature: 685°C
# Approximate Time Until Top Temperature: 8 minutes
The heat up curves for ceramic heater are as shown below
Package contains:
- Infra Tornado station
- 1 power chord cable
- megnetic stops
- flux
|
Weight 1.9 Kg.
|
Product addedd:
|
Product-related forum
|
Guarantee agreement
|
|
|
